5
Connection to a computer
When the USB cable is used to connect the camera to a computer, follow
the procedure below to select PC in the camera settings.
1 Insert the marked end of the provided USB cable into the
USB port on your computer as shown below.
• The location of the USB port varies depending on the computer.
For details, refer to your computer’s manual.
2 Plug the other end of the USB
cable into the camera’s USB
connector.
• The camera turns on automatically.
• When the camera turns on, the
lamp on the right of the viewfinder
lights up.
3 The selection screen for the
USB connection (shown
right) is displayed on the
monitor. Press
to
select PC and press
.
4 The computer recognizes the camera as a new device.
• When you connect the camera to the computer for the first time, the
computer automatically recognizes the camera. Click “OK” when the
message saying that the installation is completed appears.
• The computer recognizes the camera as a “Removable Disk”.
Look for this mark.
USB port
Terminal
Note
Lamp
GO
SELECt
Arrow pad ( )
To Next Page
Loading...
Need help?
General
