2. Preparation
19
2.4 Setting the TruRead Mode
The TruRead mode takes 3 consecutive measurements. The monitor
will inflate, take a measurement, and deflate - 3 times, separated by a
short interval between each measurement.
The TruRead mode is set to “oFF” by default.
1. Set or bypass the date and
time settings.
Follow the steps in sub-section 2.3
and set or bypass the date and time
settings.
After it is completed, the “ ”
symbol appears on the display.
2. To enable TruRead mode, press the or
button.
“ ” will appear in the display.
To keep TruRead mode disabled, press the button (rear
surface of the monitor).
3. Press the button to confirm.
If “on” is selected, the interval setting appears.
To Next Page
Loading...
Need help?
General
