55
Backplane Insulation Plates
If there is an electric potential difference between grounds when devices are
wired separately, then use a Backplane Insulation Plate. There are four models
available, corresponding to the number of slots in the Backplane. The dimen-
sions at locations A, B, C, D, and E are shown below in millimeters for each Back-
plane Insulation Plate model.
M4 screws for mounting to PC
(4/5 places)
5-dia. holes for mounting
Base Insulation Plate
(4/6 places)
135 (118)
110
(B)
C
D
(A)
(E)
12 dia.
6
5 dia.
10
Insulation Plates for CPU Backplanes
Specifications Model
Dimensions (mm)
E D C B A
For 3 slots C200H-ATT31 261 210 --- --- 246
For 5 slots C200H-ATT51 331 280 --- --- 316
For 8 slots C200H-ATT81 436 385 --- --- 421
For 10 slots C200H-ATTA1 506 455 227.5 270.5 491
Insulation Plates for CPU Backplanes
Specifications Model
Dimensions (mm)
E D C B A
For 3 slots C200HW-ATT32 190 140 --- --- 175
For 5 slots C200HW-ATT52 260 210 --- --- 245
For 8 slots C200HW-ATT82 365 315 --- --- 350
For 10 slots C200HW-ATTA2 435 385 --- --- 420
3-1-5 DIN Track Mounting
The PC may be mounted using DIN track if desired. This type of mounting is not
required, and the PC may be directly mounted to any sturdy support meeting the
environmental specifications (refer to Appendix B Specifications). If you want to
mount the PC on DIN track, you can order a DIN Track from OMRON (refer to
Appendix B Standard Models). DIN Tracks come in the two heights shown
below.
Note Never use DIN Track to mount Backplane in locations subject to vibration.
Installation Environment Section 3-1
To Next Page
Loading...
Need help?
General
