Omron E5*C-B Series User Manual

6 Parameters
6 - 66
E5@C Digital Temperature Controllers User’s Manual (H174)
hbl
Heater Burnout Latch
HB and HS alarms must be supported.
The HB ON/OFF parameter must be set to ON.
• When this parameter is set to ON, the heater burnout alarm is held until either of the
following conditions is satisfied.
a Heater burnout detection is set to 0.0 A.
b The power is cycled.
c The latch is cancelled by the PF Key.
(PF Setting = LAT: Alarm Latch Cancel)
d The latch is cancelled by an event input.
(Event Input Assignment 1 to Event Input Assignment 6 = LAT: Alarm Latch
Cancel)
• Output is turned OFF when switching to the Initial Setting Level.
 Related Parameters
Heater Burnout Detection 1 (Adjustment Level): Page 6-22
Heater Burnout Detection 2 (Adjustment Level): Page 6-23
Event Input Assignment 1 to 6 (Initial Setting Level): Page 6-57
HB ON/OFF (Advanced Function Setting Level): Page 6-65
PF Setting (Advanced Function Setting Level): Page 6-90
hbh
Heater Burnout Hysteresis
The HB ON/OFF parameter must be set to ON. The
Heater Burnout Latch parameter must be set to
OFF.
HB and HS alarms must be supported.
• This parameter sets hysteresis for heater burnout detection.
 Related Parameters
HB ON/OFF (Advanced Function Setting Level): Page 6-65
Function
Setting
Setting range Default
on: Enabled, off: Disabled off
See
See
Function
Setting
Setting range Unit Default
0.1 to 50.0 A 0.1
See
See

Omron E5*C-B Series Specifications

General

Brand	Omron
Model	E5*C-B Series
Category	Controller
Language	English