To Next Page

To Previous Page

2.3 Detailed Description of the Services

2-19

◆ Switching to Manual Mode during Auto-tuning

If the mode is switched during auto-tuning (AT), the AT will be

cancelled and the Controller will be switched to manual mode.

● Parameter Initialization

The present settings are returned to the default values and written to

EEPROM. This command can be accepted in setup area 1 only. When

this command is issued in setup area 0, an “operation error” will be

generated.

The set values that are set during initialization depend on the

command’s related information setting, as shown in the following table.

● Program Start

The simple program function can be reset/started with the related infor-

mation setting. The setting can be accepted in both setup area 0 and

setup area 1. An operation error will be generated if program start has

been set in the event input.

information

Explanation (initialization values)

00 Default initialization values (See SECTION 3 Communica-

tions Data for CompoWay/F and SYSWAY for details.)

(These settings are the same as the ones used when

“FACT” is selected for the setting data’s set value initial-

ization.)

01 Values set with the initial values setting service

(These settings are the same as the ones used when

“USER” is selected for the setting data’s set value initial-

ization.)

If the initial values have not been set yet with the initial

values setting service, the default initial values will be set.

Omron E5CN Manual

Other manuals for Omron E5CN