270
24-hour Time Switch H2E
ON/OFF Operation in Units of
15 Minutes
The only requirement for time setting is the
plugging of a setting pin into the desired hole on the
dial.
Permits manual ON/OFF operation independent of
the set time.
A power indicator lamp is provided, which permits
monitoring even during the night.
Ordering Information
Classification Control output One cycle time Min. setting time Mounting method Model
Standard type SPST-NO 24 hrs 15 min Surface mounting H2E
Flush mounting H2E-Y
Dual-circuit type DPST-NO 30 min Surface mounting H2E-2
Flush mounting H2E-Y2
Note: 1. Specify boththe modelnumber and supply voltage whenordering. All H2E-series Timers are supplied with two pairs of setting pins
(onepair foreach ON operation and OFF operation) as the standard accessories. If moresetting pins are required, also specifythe
required number of setting pins.
2. For the flush mounting types, a mounting bracket is supplied.
3. Repetitive operations can be performed in a cycle of 24 hrs.
Specifications
Time Ranges
Item H2E, H2E-Y H2E-2, H2E-Y2
Type Daily
Operation period 24-hour
Minimum division 15 min
Minimum set time 15 min 30 min
Maximum set time 23 hrs 45 min 24 hrs
Ratings
Rated supply voltage 100/110 or 200/220 VAC (50/60 Hz)
Operating voltage range 85% to 110% of rated supply voltage
Power consumption Approx. 2 VA
Control outputs 15 A at 250 VAC, resistive load (cos
%
= 1) (max. operating voltage: 250 VAC)
To Next Page
Loading...
Need help?
General
