H5CR H5CR
2
*One-shot time, seven choices selectable:
0.1 sec, 0.5 sec, 1 sec, 5 sec, 10 sec, 15 sec, 20 sec
Range selection Time unit Maximum setting
- . - - - s 0.001 second 9.999 seconds
- - . - - s 0.01 second 99.99 seconds
- - - . - s 0.1 second 999.9 seconds
- - - - s 1 second 9999 seconds
- - min - - s 1 second 99 minutes 59 seconds
- - - . - min 0.1 minute 999.9 minutes
- - - - min 1 minute 9999 minutes
- - hr - - min 1 minute 99 hours 59 minutes
- - - . - hr 0.1 hour 999.9 hours
- - - - hr 1 hour 9999 hours
■ RANGE AND OPERATION MODE SELECTION
Mode Operation Output type
A ON-delay Sustained or
A-1 Sustained start signal ON-delay one-shot*
A-2 Power ON-delay
A-3 Power ON-delay/non-power
resettable
B Repeat cycle
B-1 Repeat cycle/non-power
resettable
D OFF-delay Sustained
E One-shot
F Cumulative signal ON-delay
Description Part number
Soft cover with two mounting clips for front panel protection Y92A-48F1
Shock prevention terminal cover for Standard and Short body timers protects wiring connections Y92A-48T
Sockets 8-pin, bottom surface or track mounting, top screw terminals P2CF-08
8-pin, bottom surface or track mounting, top screw terminals, finger safe terminal
conforms to VDE0106/P100 P2CF-08-E
8-pin, back mounting, for use with Y92F-30 mounting adapter, bottom screw terminals P3G-08
8-pin, terminal cover for P3G sockets, conforms to VDE0106/P100 Y92A-48G
Panel mounting adapter Fits behind panel, ideal for side-by-side installation. Use P3G❑-❑ sockets Y92F-30
NEMA 4 cover Waterproof front cover Y92A-48N
Mounting track DIN rail, 50 cm (1.64 ft) length; 7.3 mm thick PFP-50N
DIN rail, 1 m (3.28 ft) length; 7.3 mm thick PFP-100N
DIN rail, 1 m (3.28 ft) length; 16 mm thick PFP-100N2
End plate PFP-M
Spacer PFP-S
■ ACCESSORIES
Part number H5CR-L❑ H5CR-B❑ H5CR-S❑
Classification Economy type Standard type Short body type
AC 100 to 240 VAC, 50/60 Hz, 100 to 240 VAC, 50/60 Hz, —
24 VAC, 50/60 Hz 24 VAC, 50/60 Hz
DC 12 to 24 VDC, 20% max. — 12 to 24 VDC, 20% max.
permissible ripple permissible ripple
Operating voltage 85% to 110% of rated voltage
AC 3 VA at 60 Hz, 240 VAC —
DC 1 W at 24 VDC — 2 W at 24 VDC
Specifications
Supply
voltage
Power
consumption
Specifications table continued on next page.
To Next Page
Loading...
Need help?
General
