K3MA-J
6
Convenient Functions
Scaling Teach
The parameters (inp.1, inp.2) for the K3MA-J’s initial setting level can be set using actual input values with the teaching function. After displaying
the parameters, the actual input settings can be made with the following operation.
OUT Types (Comparative Output Models Only)
OUT 1 and OUT 2 can be set to operate in one of the three following modes in accordance with the compared values:
• Upper limit (High Acting):
The output is turned ON when the measurement value is greater than its set value.
• Lower limit (Low Acting):
The output is turned ON when the measurement value is less than its set value.
• Upper and lower limits (Outside Band Acting):
An upper limit (H set value) and lower limit (L set value) can be set independently.
The output is turned ON when the measurement value is greater than upper-limit set value or less than the lower-limit set value.
The three types of output operations shown above can be combined as desired. The following are examples of possible combinations.
“T” lights to
indicate that the
parameter is
valid for teaching.
Monitor mode
Teaching mode
“T” flashes.
Normal change
“T” turns OFF.
Use to register
and shift to monitor
mode.
Use to shift to
the next parameter
without registering.
Next parameter
Upper Limit (High Acting) Lower Limit (Low Acting)
OUT1/2 value
Measurement value
ON
OFF
Output
ON
OFF
Output
ON
OFF
Output
OUT1/2 value
Measurement value
Measurement value
Hysteresis
Hysteresis
Hysteresis
Hysteresis
Upper and Lower Limits
(Outside Band Acting)
OUT1/2 upper-limit value
OUT1/2 lower-limit value
Upper Limit 2-stage Output Threshold Output Combination of Upper Limit and
Upper/Lower Limits
OUT2
value
OUT1
value
OUT2
OUT1
ON
OFF
OFF
ON
OUT2
OUT1
ON
OFF
OFF
ON
OUT2
OUT1
ON
OFF
OFF
ON
Measurement
value
Measurement
value
Measurement
value
OUT2 upper-limit
value
OUT1 upper-limit
value
OUT1 lower-limit
value
OUT2 lower-limit
value
OUT2 Upper-limit
value
OUT1 value
OUT2 Lower-limit
value
To Next Page
Loading...
Need help?
General
