4-1
CHAPTER 4 Adjustment
1 Overview
OMRON robots have been completely adjusted at the factory or sales repre-
sentative before shipment, including the Z-axis origin position adjustment.
However, when the operating conditions are changed and adjustment of the
robot becomes necessary, follow the procedure described in this chapter.
2 Safety Precautions
(1) Read and understand the contents of this chapter completely before
attempting to adjust the robot.
(2) Place a conspicuous sign indicating the robot is being adjusted, to prevent
others from touching the controller switch, programming box or operation
panel.
(3) If a safeguard enclosure has not yet been provided right after installation of
the robot, rope off or chain off the movement area around the manipulator
in place of a safeguard enclosure, and observe the following points.
1- Use stable posts which will not fall over easily.
2- The rope or chain should be easily visible by everyone around the robot.
3- Place a conspicuous sign prohibiting the operator or other personnel
from entering the movement area of the manipulator.
(4) To check operation after adjustment, refer to “6. Trial Operation” in Chapter 1.
To Next Page
Loading...
Need help?
General
