Omron SYSMAC C28K Installation Guide

Appendix BSpecifications
65
Input Specifications
DC input (photocoupler–isolated)
24 VDC ±10%
3 k
Ω
7 mA at 24 VDC
15 VDC min.
5 VDC max.
2.5 ms max. (input 0000 and 0001: 0.15 ms)
2.5 ms max. (input 0000 and 0001: 0.15 ms)
Supply voltage
Input voltage
Input current
ON voltage
OFF voltage
ON delay time
OFF delay time
AC input* (photocoupler–isolated)
100 to 120 VAC + 10%, –15% 50/60 Hz
9.7 k
Ω (50 Hz), 8 kΩ (60 Hz)
10 mA at 100 VAC
60 VAC min.
20 VAC max.
35 ms max.
55 ms max.
+
+ 24
VDC
IN
Internal
Circuit
Photocoupler
3 k
Ω
470 Ω
COM
IN
Internal
Circuit
Photocoupler
330
Ω
COM
100 to
120
VAC
330 k
Ω
180 Ω
0.33 µF
* Inputs 0000 and 0001 operate on DC input voltage. The circuit configuration of these two points is the same as the DC input circuit
shown above.
Note : The 24 VDC power source can be connected to either the positive or the negative terminal. Therefore both PNP input (negative
common) and NPN (positive common) can be used.
Output Specifications
24
VDC
COM
COM
Internal Circuit
X
OUT
L
250 VAC
Load power supply
L
Internal Circuit
OUT
Load power supply
+
5 to 24 VDC
L
COM
Internal Circuit
OUT
Load power supply
+
100 to 120/
200 to 240
VAC
Relay
(photocoupler–
isolated)
Transistor*
(photocoupler–
isolated)
Triac*
(photocoupler–
isolated)
ON–delay
15 ms max.
1.5 ms max.
1.5 ms max.
OFF–delay
15 ms max.
1.5 ms max.
1/2 of load
frequency +
1 ms max.
Circuit configuration
Max.
2 A at 250 VAC
2 A at 24 VDC
(p.f. 1)
0.5 A at 250 VAC
(p.f.0.4)
4 A/Common (4 points/Common)
6 A/Common (8 points/Common)
1 A/point at 5 to
24 VDC,
1.6 to 4 A/4 points
4 A/Common (4 points/Common)
6 A/Common (8 points/Common)
1 A/point at 85 to
250 VAC,
1.6 to 4 A/4 points
4 A/Common (4 points/Common)
6 A/Common (8 points/Common)
Min.
10 mA at
5 VDC
10 mA at
5 VDC,
saturation
voltage:
1.5 V max.
10 mA at
100 VAC,
20 mA at
200 VAC
Switching capacity

Omron SYSMAC C28K Specifications

General

Brand	Omron
Model	SYSMAC C28K
Category	Controller
Language	English