55
Example
0000
0000SCAN
TIME
AVG 054.1MS
0000SCAN TIME
AVG 053.9MS
4-6-5 Program Searches
The program can be searched for occurrences of any designated instruction
or data area bit address used in an instruction. Searches can be performed
from any currently displayed address or from a cleared display.
To designate a bit address, press SHIFT, press CONT/#, then input the ad-
dress, including any data area designation required, and press SRCH. To
designate an instruction, input the instruction just as when inputting the pro-
gram and press SRCH. Once an occurrence of an instruction or bit address
has been found, any additional occurrences of the same instruction or bit can
be found by pressing SRCH again. SRCHG will be displayed while a search
is in progress.
When the first word of a multiword instruction is displayed for a search opera-
tion, the other words of the instruction can be displayed by pressing the down
key before continuing the search.
If Program Memory is read in RUN or MONITOR mode, the ON/OFF status
of any bit displayed will also be shown.
Key Sequence
Inputting, Modifying, and Checking the Program Section 4-6
To Next Page
Loading...
Need help?
General
