Omron SYSMAC C28K User Manual

72
If the condition assigned 0004 was not in the diagram, the second LD using
TR 0 would not be necessary because OUT with 0102 and the AND NOT
with 0005 both require the same execution condition, i.e., the execution con-
dition stored in TR 0. The diagram and mnemonic code for this program are
shown below.
0000 0001 0002
0003
0005
0100
0101
0102
0103
TR
0
TR
1
Address Instruction Operands
0000 LD 0000
0001 OUT TR 0
0002 AND 0001
0003 OUT TR 1
0004 AND 0002
0005 OUT 0100
0006 LD TR 1
0007 AND 0003
0008 OUT 0101
0009 LD TR 0
0010 OUT 0102
0011 AND NOT 0005
0012 OUT 0103
When coding IL(02) and ILC(03), the mnemonic code will be the same re-
gardless of whether the instruction is drawn as branching instruction lines or
whether IL(02) is placed on its own instruction line. If drawn as branching
instruction lines, each branch line is coded as if it were connected to the bus
bar, i.e., the first condition on each branch line corresponds to a LD or LD
NOT instruction.
0002
0000 0001
ILC(03)
IL(02)
0004
IL(02)
0006
0005
0003
0100
0101
0102
0103
Address Instruction Operands
0000 LD 0000
0001 IL(02)
0002 LD 0001
0003 OUT 0100
0004 LD 0002
0005 IL(02)
0006 LD 0003
0007 AND NOT 0004
0008 OUT 0101
0009 LD 0005
0010 OUT 0102
0011 LD 0006
0012 OUT 0103
0013 ILC(03)
Interlocks
Data Areas, Definer Values, and Flags Section 5-4

Omron SYSMAC C28K Specifications

General

Brand	Omron
Model	SYSMAC C28K
Category	Controller
Language	English