ix
About this Manual:
This manual has been prepared to provide the information necessary to install, set up, and maintain
your C-series P-type Programmable Controller, a low-cost, compact, versatile industrial control sys-
tem providing up to 148 I/O points. For information regarding system programming and operation,
refer to the Operation Manual.
Analog I/O Units are also not described in detail in this manual because a separate manual is pro-
vided for them (SYSMAC K-type Analog I/O Units Operation Guide, Cat.No. W122)
Section 1 describes the basic Units that can be used to build a K-type PC, explains how the Units
can be combined, and provides example system configurations.
Section 2 covers actual system installation and wiring, including switch settings.
Section 3 provides information on maintaining your PC in good working condition.
WARNING Failure to read and understand the information provided in this manual may result in
personal injury or death, damage to the product, or product failure. Please read each
section in its entirety and be sure you understand the information provided in the section
and related sections before attempting any of the procedures or operations given.
To Next Page
Loading...
Need help?
General
