Appendix DProgramming Console Operations
85
*Modes in which the given instruction is applicable: R = RUN, M = MONITOR, P = PROGRAM
Operation/Description Key sequenceModes*
DM Data Save, Restore, Compare
The procedures for transferring DM
area data to and from tape, and for
comparing it, are basically the same
as for the Program Memory, given
above. The exceptions are that start
and stop addresses are not required,
and the DM area is specified instead
of the Program Memory. Each
operation will continue through to the
end of the tape unless cancelled by
pressing clear.
P
EXT
CLR
[File no.]
VER
B
1
Start tape recorder
playback.
SHIFT
SHIFT
REC
RESET
PLAY
SET
Start tape recorder re-
cording.
5 second leader tape
PROM Writer Operations
Operation/Description Modes* Key sequence
PC to PROM Writer
Outputs Program Memory to the
RS-232C interface for writing to a
commercial PROM writer.
P
Start PROM writer
reception
PROM Writer to PC
Read Program Memory data from a
commercial PROM writer into the PC
via the RS-232C interface.
P
Start PROM writer
transmission
To Next Page
Loading...
Need help?
General
