1-4
Support Software
The Support Software that is used depends on the system configuration.
• Support Software for a System Configured with a CPU Unit
If your system is configured by connecting an NX Unit to a CPU Unit, the Sysmac Studio is used as
the Support Software.
• Support Software for a System Configured with a Slave Terminal
If your system is configured by connecting an NX Unit to a Communications Coupler Unit, refer to
the user’s manual for the Communications Coupler Unit for information on the Support Software.
• Support Software for a System Configured with a Communication Control Unit
If your system is configured by connecting an NX Unit to a Communication Control Unit, the Sysmac
Studio is used as the Support Software.
Depending on the Unit to which the NX Unit is connected, refer to the following appendices for infor-
mation on the Support Software versions.
• A-5 Version Information with CPU Units on page A-29
• A-6 Version Information with Communications Coupler Units on page A-31
• A-7 Version Information with Communication Control Units on page A-34
1 Features and System Configuration
1-13
NX-series System Units User's Manual (W523)
1-4 Support Software
1
To Next Page
Loading...
Need help?
General
