Omron TM Series User Manual

Medium & Heavy Payload Series-Hardware Installation Manual TM12/14 Series Hardware Version: 3.2 64
5.6 Control Box Power Interface and Robot Interface
5.6.1 Control Box Power Interface
TM12 / TM14 / TM12X / TM14X:
The power cable of the control box has an IEC plug. The local power plug is connected to the IEC plug.
The AC power switch must be in OFF state before plugging in or out the power cable.
TM12M / TM14M:
The power cable of the control box has Hirose (HRS) DF60 series connector.
Figure 62: Control Box Power Interfaces
The power supply should be equipped with the following:
• Grounding
• Main fuse
• Residual current device (RCD)
It is recommended to install a master switch on the equipment power supply for robot applications for
servicing and inspection.
Parameters Minimum value Typical value Maximum value Unit
Input voltage 100 - 240 VAC
External mains fuse
(100V~120V)
- - 15 A
AC Adapter
AC Adapter：IEC plug
DC IN Power Connector：（ HRS）DF60-3EP-10.16C
DC IN for External Power Supply Connector： Contact the Corporation for
purchasing
External Power Supply Remote Control Connector：Contact the Corporation
for purchasing
DC IN Power
External Power Supply Remote Control
DC IN for External Power Supply
-
+
TM12M / TM14M
TM12 / TM14 / TM12X / TM14X

Omron TM Series Specifications

General

Brand	Omron
Model	TM Series
Category	Robotics
Language	English