Advanced Industrial Automation
Rotating and static autotune
Besides the standard rotating autotune function, the new
V7 series also features static autotune. This greatly eases drive
setup by eliminating the need to rotate the motor during
autotuning. The result - faster, easier and cheaper installation
and commissioning.
Position control at stop
Embodying advanced on-board processing, V7 inverters offer
unrivalled dynamic control, including fast braking and high-
precision positioning at stop. From full speed to full stop is
achieved faster than market standard inverters. Moreover, this
braking performance is completely independent of the motor
running speed, providing you with perfect control of
your machines.
Packaging feed
Positioning
Speed
S: Travel distance
(blue area)
S
Time
Nominal speed
S>S
Standard stop at
nominal speed.
Stopping without
position control.
Stopping with
position control.
Preferred stop position
Unexpected stop position
New features
• Sensor-less vector controller
ensures 100% at 0.5Hz
• Compact size available
in IP20 or IP65
• Silent operation
• Programming software:
CX-Drive for parameter configuration
• CASE (Inverter application software)
• PLC option board
• High speed Motion Bus: MECHATROLINK-II (ML-II)
• Connectivity: Memobus, Dnet, Profibus, CANopen
• New features:
- Autotuning
- Position control when stopping
- Carrier frequency up to 14KHz
- Analogue positioning
- Improved Up & Down function
- PTC input
- 2 Motors change function
- Free I/O’s setting to be used
from host controller
- Frequency Offsets
- New start / stop sequence
To Next Page
Loading...
Need help?
General