EasyManuals Logo
Home>Onan>Portable Generator>BGE

Onan BGE User Manual

Onan BGE
34 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
INSTALLATION
REVIEW
Prior to initial start-up
of
generator set, address each of the following installation review items. For a safe and effective
installation, each answer must be affirmative; if not, that aspect
of
the installation should be reworked or provision madl
to satisfy the requirement.
J
1.
Does the exhaust system extend to the perimeter of the vehicle, and not below an open-
2.
Are all required exhaust clamps, hangers and support straps in place per kit
3.
Do
the hanger straps located at the perimeter and along the centerline
of
the generator
4.
is the compartment metal-lined and sealed around all edges?
5.
Is
a flexible section of non-conducting fuel line installed between the fuel inlet and the
6.
Does the installation allow
112
inch
(13
mm) free movement of generator set on its
7.
Are all fuel connections and hose clamps tight?
8.
Is
there
85
in*
(548
cm2) of free air inlet?
9.
Is generator set protecfed from direct road splash from vehicle wheels?
or removal or cover panel,
or
swing down/drop out of generator set):
0
Change Oil and Filter
0
Carburetor Adjustments
Startistop the Unit
0
Change
Air
Filter
Governor Adjustments
0
Operate AC Circuit Breakers
0
Change Spark Plugs
0
Change Ignition Points
able window or door?
instructions?
set have double
“U”
shaped rubber isolators?
fuel line from tank?
mounts?
10.
Can the following routine maintenance items be performed (through vehicle access door
1
1.
Are fuel lines and electrical wires run separately?
12.
Are wiring holes into the inside of coach (including the inside of
AC
conduit) sealed to
13.
Has rubber boot been installed on battery plus
(+)
lead at the start solenoid connection in
14.
On a liquid propane generator set, has system been tested for leaks?
15.
If installation uses under-floor hinge kit, is there
2
inches
(51
mm) clearance between
front of tray and vehicle skirt (or
is
skirt
part of door) to allow set to swing down for
service?
16.
Are
all
electrical leads connected and protected, and conduit
is
adequately supported?
prevent passage of exhaust gases?
the
control?
.
28
Redistribution or publication of this document,
by any means, is strictly prohibited.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Onan BGE and is the answer not in the manual?

Onan BGE Specifications

General IconGeneral
BrandOnan
ModelBGE
CategoryPortable Generator
LanguageEnglish

Related product manuals