Playing music using the audio cable
Switching the headphones on
Playing music wirelessly
Switching the headphones off
Use the audio cable to listen to music when the headphones are running out of battery or when
Bluetooth transmission is restricted or not allowed.
Using the headphones
Press the multifunction button for 3 seconds. You hear the voice prompts “ power on” and the LED
flashes between blue and red when the headphones are active.
The following music functions are only available when the headphones and your device are
connected via Bluetooth. Some smartphones, music apps or players may not support all functions.
Press the multifunction button for 3 seconds. You hear the voice prompt “power off” and the LED
light turns off, indicating the headphones are off.
Adjusting the volume
Press the volume +/- buttons once to increase or decrease the volume. When the maximum or
minimum volume is reached, you hear an alert tone.
The headphones immediately switch off once the audio cable is plugged into the audio input.
Playing/pausing music: quickly press the multifunction button.
Playing the next/previous track: press and hold the volume+/- button
1. Insert the 3.5mm jack plug into the audio input of the headphones. Bluetooth is deactivated.
2. Connect the 3.5mm jack plug to the audio output of your smartphone.
Inserting the audio cable
5
To Next Page
Loading...
Need help?
General