64
Using the Timers
The CD/HDD receiver has three timers: the sleep timer
for turning the CD/HDD receiver off after a specified
period, the play timer for automated playback, and the
record timer for automated recording.
Up to four programmable timers are available for the
play and record timers.
The timers can be used with other Onkyo components
that are connected to the CD/HDD receiver via u (
see
page 19
for hookup details).
With the sleep timer, you can set the CD/HDD receiver
so that it automatically turns off after a specified period.
This timer is convenient when you want to fall asleep
while listening to music.
Checking the Remaining Sleep Time
To check the remaining sleep time, press the [SLEEP]
button.
Note that if you press the [SLEEP] button while the
remaining sleep time is 10 minutes or less, the sleep
timer is canceled..
Canceling the Sleep Timer
To cancel the sleep timer, press the [SLEEP] button
repeatedly until “Sleep Off” appears and the SLEEP
indicator disappears.
Note:
During recording, the sleep timer can be set. When the sleep
time period has expired during recording, the
CD/HDD
receiver
will cancel the recording and enter the Standby
mode.
TIMERSLEEP
Using the Sleep Timer
1
Press the [SLEEP] button repeat-
edly to select the required sleep
time.
The SLEEP indicator and “Sleep 90
min” appear on the display, as shown.
With the [SLEEP] button, you can set
the sleep time from 90 to 10 minutes in
10 minute increments.
To set the sleep time in 1 minute incre-
ments from 99 to 1, use the Up and
Down [
q]/[w] buttons during the sleep
time is displayed. The sleep time
appears on the display for about 8 sec-
onds, then the previous display reap-
pears.
Sleep 90 min
SLEEP indicator
To Next Page
Loading...
Need help?
General
