Replacing
the
Battery
Aiming
the
Remote
Controller
Use
only a battery
of
the same type
(CR
2025).
1.
To
open the battery compartment, press
the small
hollow
and slide open
the
cover.
When using the remote controller,
point
it
toward the
RI
Dock's remote control sensor,
as
shown below.
RI
Dock
30'
Notes:
•
If
the
Rl
Dock
is
placed on
top
of
another
component, the remote controller's sig-
nal may be obstructed and
the
remote
controller may
not
work
reliably.
• The remote controller may
not
work
reli-
ably
if
the
Rl
Dock
is
subjected
to
bright
light, such
as
direct sunlight
or
inverter-
type fluorescent lights. Keep this in mind
when installing.
•
If
another remote controller
of
the
same
type
is
used in the same room,
or
the
RI
Dock
is
installed close
to
equipment
that
uses
infrared
rays,
the
remote controller
may
not
work reliably.
• Don't
put
anything on
top
of
the remote
controller, such
as
a book
or
magazine,
because a
button
may be pressed contin-
uously, thereby draining the batteries.
• The remote controller may
not
work
reli-
ably
if
the
RI
Dock
is
installed in a rack
behind colored glass doors. Keep this in
mind when installing.
• The remote controller will
not
work
if
there's an obstacle between
it
and
the
RI
Dock's remote control sensor.
Notes:
•
If
the remote controller doesn't
work
reli-
ably,
try
replacing the battery.
•
If
you intend
not
to
use
the remote con-
trollerforalong time, remove
the
battery
to
prevent damage from leakage or cor-
rosion.
•
An
expired battery should be removed
as
soon
as
possible
to
prevent damage
from
leakage
or
corrosion.
Caution: Replacing
the
battery incorrectly
may cause an explosion.
Use
only a battery
of
the
same
type
or
an
equivalent.
3. Slide the cover shut.
2. While pressing the tab
as
shown, slide
out
the old battery.
Slide
the
new battery
into
the battery com-
partment
with
the positive side facing up.
7
To Next Page
Loading...
Need help?
General
