Setting
the
TV
System
(European model only)
While
the
OSD
mode
is
set
to
On, you can set
the
RI
Dock's video
output
to
PAL
or
NTSC.
If
the
onscreen display looks distorted on your
TV,
try
changing
the
TV
system.
• While pressing and holding
down
the
[SETUP]
button,
press
the
VOLUME
Up
[.
]
button
for more than 3 seconds
to
select
NTSC,
or press
the
VOLUME
Down [ T ]
but-
ton
for more than 3 seconds
to
select
PAL.
Other
Functions
• R I Functions
Depending on your amp and generation
of
iPod/iPhone, you may also be able
to
use
the
following functions.
Note:
• Your amp may take several seconds
to
startup,
so
you
might
not
hear the first
few seconds
of
the
first song/video.
• System On Function
When you
turn
on your amp,
the
iPod/iPhone
turns on
as
well. With some amps, you may
need
to
press
the
[ON]
button
on your amp's
remote controller's twice
to
turn
on
the
other
components in your system.
• System
Off
Function
When you
turn
off
your amp, the iPod/iPhone
turns
off
as
well.
• Auto Power On Function*
If
you start iPod/iPhone playback while your
amp
is
on Standby, your amp will automatically
turn
on and select your iPod/iPhone
as
the
input
source. Then, your iPod/iPhone will start
playback.
• Direct Change Function*
If
you start iPod/iPhone playback while listen-
ing
to
another
input
source, your amp will
automatically select your iPod/iPhone
as
the
input
source.
* Ifyou use your iPod/iPhone model's controls
to
start an
iPod/iPhone slideshow
or
video, these functions will
not
work,
so use
the
remote controller instead.
12
• Timer Play
You
can
use your amp's Timer function
to
turn
on your
amp
and iPod/iPhone and start play-
back at a specified time.
• Using Your Amp's Remote Controller
You
can use your amp's remote controller
to
control basic iPod/iPhone functions
(see
page
14).
Operating Notes:
• The
RI
Dock must be connected
to
your
amp
with
both
an
R I cable and
an
audio
cable
to
use
the R I functions.
• Ifyour
amp
doesn't
support
the System
On,
System Off, Auto Power On, and
Direct Change functions, you'll need
to
turn
your amp on and
off
and select
the
input
source manually.
• Before you select another
input
source,
stop iPod/iPhone playback
to
prevent
yourampfrom selecting
the
iPod/iPhone
input
source by mistake.
• Ifany accessories are connected
to
your
iPod/iPhone, your amp may
not
be able
to
select the
input
source properly.
• While your iPod/iPhone
is
in
the
RI
Dock,
its volume control
has
no
effect.
If
you
adjust your iPod/iPhone model's volume
control while it's in
the
RI
Dock, make sure
it's
not
set
too
high before you reconnect
your
headphones.
To Next Page
Loading...
Need help?
General
