Onkyo HT-RC260 User Manual

56
En
You’ll need to enter a code for each component that you
want to control.
Note
• The remote control codes provided are correct at the time of
printing, but are subject to change.
Onkyo components that are connected via u are con-
trolled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.
If you want to control an Onkyo component by pointing
the remote controller directly at it, or you want to control
an Onkyo component that’s not connected via u, use the
following remote control codes:
• BD/DVD
` 30627
:
Onkyo DVD player without u
• TV/CD
` 71817
:
Onkyo CD player without u
` 11807:
Onkyo TV
If you want to control an Onkyo component by pointing the
remote controller directly at it, use the following remote
control codes:
` 32900
:
Onkyo Blu-ray Disc player
` 32901:
Onkyo HD-DVD player
` 70868:
Onkyo MD recorder
` 71323:
Onkyo CD recorder
` 82990:
Onkyo Dock
Note
• If you connect a cassette tape deck to the TV/CD IN jack, or
connect an RI Dock to the to the TV/CD IN or VCR/DVR IN or
GAME IN jacks, for u to work properly, you must set the Input
Display accordingly (➔ 22).
Entering Remote Control Codes
1
Look up the appropriate remote control code in
the separate Remote Control Codes list.
The codes are organized by category (e.g., DVD
player, TV, etc.).
2
While holding down REMOTE MODE to which
you want to enter a code, press and hold down
DISPLAY (about 3 seconds).
Note
The remote indicator lights.
• Remote control codes cannot be entered for RECEIVER
and ZONE 2.
• Only TV remote control codes can be entered for TV.
• Except for RECEIVER, TV and ZONE 2, remote control
codes from any category can be entered as REMOTE
MODE. However, these buttons also work as input selec-
tor buttons (➔ 20), so choose a REMOTE MODE that
corresponds with the input to which you connect your
component. For example, if you connect your CD player
to the CD input, choose TV/CD when entering its remote
control code.
3
Within 30 seconds, use the number buttons to
enter the 5-digit remote control code.
The remote indicator flashes twice.
If the remote control code is not entered success-
fully, the remote indicator will flash once slowly.
Remote Control Codes for Onkyo
Components Connected via u
1
Make sure the Onkyo component is connected
with an u cable and an analog audio cable
(RCA).
See “Connecting Onkyo u Components” for
details (➔ 17).
2
Enter the appropriate remote control code for
REMOTE MODE.
• BD/DVD
` 31612:
Onkyo DVD player with u
• TV/CD
` 71327:
Onkyo CD player with u
` 42157:
Onkyo cassette tape deck with u
• PORT
` 81993:
Onkyo Dock
See the previous section for how to enter remote
control codes.
Note
• When using a cassette tape deck connected via u, press
and hold TV/CD to switch to TAPE.
3
Press REMOTE MODE, point the remote control-
ler at the AV receiver, and operate the component.

Onkyo HT-RC260 Specifications

General

Brand	Onkyo
Model	HT-RC260
Category	Receiver
Language	English