Onkyo TX-930 User Manual

Before using this unit
1. Supplied Accessories
AM Ioop T-shaped FM
antenna x 1 antenna ~x 1
‘1 Push the battery cover on the rear of the transmitter in the direction
of the arrow and lift it up.
‘2) Load the two batteries that came with the transmitter or two
batteries listed in the table. Load them with the (+) and (—) ends
facing as shown in the diagram.
(3) Put the battery cover back in place.
(RI
f21 remote contro! cable x 1 Remote control transmitter « 1
: Remote Interactive) Battery x 2
-
pam
oe AM
Use of Batteries
The remote control transmitter is powered by two batteries. Before
using this unit for the first time, insert the two batteries (included) as
shown in the diagram.
Average battery life is about one year. This period may be shorter
depending on the frequency of use and environment (temperature
and humidity) in which the remote control transmitter is used.
If the remote contro! transmitter does not operate even though front
panel controls function normally, the batteries should be replaced.
Use only batteries listed in the following chart.
Type Voltage Size
AA
1.5V R6
UM-3
NOTES:
1.
Do not leave an expired battery in the case as it may leak or
damage the battery case.
When inserting the batteries, be sure the (+) and (—) ends are
properly aligned.
Do not use nickel-cadmium (rechargeable) batteries.
Do not use one specified (manganese) battery and one aikaline
battery at the same time.
Repiace both batteries at once; do not use one old and one new
battery together.

Onkyo TX-930 Specifications

General

Brand	Onkyo
Model	TX-930
Category	Amplifier
Language	English