EasyManuals Logo

Onkyo TX-SR508 User Manual

Onkyo TX-SR508
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #48 background imageLoading...
Page #48 background image
48
En
Controlling Zone 2 with the Remote
Controller
Note
To control Zone 2, you must press the remote controller’s
ZONE2 first.
Adjusting the Volume for Zone 2
Operating with the remote controller
Operating on the AV receiver
If your Zone 2 speakers are connected to a receiver or inte-
grated amp in Zone 2, use its volume control to adjust the
volume.
Muting Zones
Operating with the remote controller
To unmute a zone
Note
Only analog input sources are output by the ZONE 2 LINE
OUT and FRONT HIGH OR ZONE2 L/R speaker terminals.
Digital input sources are not output. If no sound is heard when
an input source is selected, check if it’s connected to an analog
input.
While Powered Zone 2 is being used, listening modes that
require surround back and front high speakers (6.1/7.1), such as
Dolby Pro Logic IIz Height, Dolby Digital EX, and DTS-ES are
unavailable.
While Zone 2 is on, u functions will not work.
You cannot select different AM or FM radio stations for your
main room and Zone 2. The same FM/AM radio station will be
heard in each room. For example, if you have an FM station for
the main room, that station will also be used in Zone 2.
Zones can also be unmuted by adjusting the volume.
1
Press ZONE2, and then press ON/STANDBY.
Zone 2 turns on, the ZONE 2 indicator lights.
2
To select an input source for Zone 2, press
ZONE2, followed by an INPUT SELECTOR.
To select AM or FM press the TUNER input selector
repeatedly.
(North American models) You can also select SIR-
IUS.
Note
You cannot select different AM or FM radio stations for
your main room and Zone 2. The same FM/AM radio sta-
tion will be heard in each room.
3
To turn off Zone 2, press ZONE2 followed by ON/
STANDBY.
ON/STANDBY
INPUT SELECTOR
MUTING
VOLq/w
ZONE2
1
Press ZONE2
2
Use VOL q/w
1
Press ZONE 2 (the ZONE 2 indicator and Zone 2
selector on the display flashes)
2
Use –/+ within 8 seconds
1
Press ZONE2
2
Press MUTING
1
Press ZONE2
2
Press MUTING again

Table of Contents

Other manuals for Onkyo TX-SR508

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Onkyo TX-SR508 and is the answer not in the manual?

Onkyo TX-SR508 Specifications

General IconGeneral
Impedance4 Ω
Frequency range5 - 100000 Hz
Audio output channels7.1 channels
Signal-to-Noise Ratio (SNR)106 dB
Total Harmonic Distortion (THD)0.08 %
AM band range522 - 1611 kHz
FM band range87.5 - 108 MHz
Radio Data System (RDS)Yes
Package depth537 mm
Package width416 mm
Package height268 mm
Dimensions (WxDxH)435 x 151 mm
Power requirementsAC 230 V, 50 Hz
Product colorBlack
Power consumption (typical)450 W
Package weight12000 g
Weight and Dimensions IconWeight and Dimensions
Weight9400 g

Related product manuals