34
AIR CANOPY SET-UP
Locate the canopy air transfer valve inside your OPUS. This is the black valve located on your main air beam in the camper on the door-side,
just above the window.
Install the Cross Filling Tube… by unscrewing the top of the black valve, pushing the gray tube on to the valve and then threading the top of
the black valve over the tube and twisting it on. Thread the end of the Cross Filling Tube through the silver loop hole in the OPUS side wall.
Open the air transfer valve – please note that this will cause your tent to deflate. You can also open the quick release valves to deflate faster.
You will need to do this to attain easy access to the zip line attachment on the front face of your tent.
Open up AIR canopy as shown and identify the zip & Velcro line which is how your will attach the canopy to your main tent and layout your
canopy with the two front leg beams furthest from the camper.
Zip - Our recommendation is to then stand between the OPUS and the canopy and start zipping at the door side, walking backwards be-
tween the OPUS and the canopy as you close the zip. This will assist in locating both the Cross Filling Tube that you installed on the main
OPUS tent as well as the receiving valve on the canopy-side about half-way along the zip line. The receiving valve is located on the central air
pole of your canopy..
Once located, connect the Cross Filling Tube to the receiving valve on the side of the canopy. Take care to ensure that the spring is inside
the grey tube to help protect the hose from getting kinked. Install the tube to the receiving valve in the same way as in step (2) except you
will need to thread the top of the valve on to the Cross Filling Tube before you push the tube on to the valve. Twist the top of the valve on, to
secure the tube in place.
Open the valve on the canopy-side. Finish zipping the canopy to the side of the OPUS and fold the Velcro flap over the zip.
SETTING-UP THE OPUS AIR CANOPY
STEP 1
STEP 2
STEP 3
STEP 5
STEP 6
STEP 7
VELCRO