15
Continuing to hold down both keys will light the
third LED indicating that the Treble adjust mode
has been activated. In this mode, pressing the
Volume up or down keys will adjust the treble
(high frequencies) level.
Continuing to hold down both buttons will light
the fourth LED indicating that the Balance adjust
mode has been activated. In this mode, pressing
the Volume up or down keys will adjust the sound
level between the left and right speakers.
Continuing to hold down both buttons will light
the fifth LED indicating that the Fader adjust
mode has been activated. In this mode pressing
the Volume up or down keys will adjust the
balance between the main speakers and anything
that is connected to the preamp output. This
adjustment is relevant only if the preamp output is
used. The Volume up and down buttons on the
remote control can also be used to adjust the
sound in each mode.
Note: If no adjustment is made, the system will automatically go back to volume adjustment
after two seconds.
Bass Treble Balance Fader
To Next Page
Loading...
Need help?
General