16
Note: This feature is only available if the WCU330
is part of a full Opus 300 multi-room system with
one or two Local Input Modules (LIM300) fitted.
The local source selection mode will need to be
activated to configure the WCU330 correctly. This
mode is only available when the Mode Switch is
set to ‘Opus 300’ (enhanced A-BUS
®
) mode.
LIM300s can only be used in this mode. Please
refer to your LIM300 Installation Guide for more
information.
Pressing the Select left or right buttons on the
keypad allows you to rotate through all six
sources as default. However, it is possible to
allow the addition of one or two local sources by
accessing Local source selection mode. To
enter this mode press the Volume up button
simultaneously with the Power button for four
seconds; the LED display will then scroll through
the sequence shown in the illustration at right and
described as follows:
After holding down both buttons for a short period, LED 2 will light indicating that Sources
1–6 (default) are available for selection.
Continuing to hold down both keys will light LED 3 indicating that Sources 1–6 and Local
Source 1 mode are available for selection.
Continuing to hold down both buttons will light LED 4 indicating that Sources 1–6, Local
Source 1 and Local Source 2 mode are available for selection.
Local source selection
2 3 4 5
To Next Page
Loading...
Need help?
General