17
Continuing to hold down the Volume up and Power buttons will light LED 5, indicating that
Off mode is available for selection and no source will be selected.
To select these modes, wait till the corresponding LED is lit and then release Power and
Volume up buttons.
Note: If no adjustment is made, the system will automatically go back to volume
adjustment after two seconds. If ‘Standard A-BUS/Opus 500’ mode is selected on the
Mode switch, the WCU330 will only rotate around the main six sources.
Remote control
The WCU330 can be used with the Opus LRC300 remote control, a
sophisticated learning remote which is able to learn the codes of all
the source equipment remotes. Once programmed the user can thus
use the LRC300 to perform all operations from one remote.
The LRC300 is also suitable where the WCU330 is connected to the
A-BUS
®
Ready outputs of AV receivers and amplifiers other than an
Opus hub. It can learn the relevant source change commands, etc. of
the receiver or amplifier, as well as the source equipment.
Note: Please refer to the Opus LRC300 manual for further information.
To Next Page
Loading...
Need help?
General