Opus WCU330 User Manual

8
A-BUS
®
Ready/Opus 500 System
For use with an A-BUS
®
Ready/Opus 500 System (see diagram opposite) the Mode switch
must be in the ‘Standard A-BUS
®
/Opus 500’ position as shown below:
WCU330-EU rear
In this configuration the keypad is wired directly to the Opus DZM amplifier. It is not possible
to switch sources using the hard buttons on the WCU330, but this can be achieved by using
Opus remote controls.
Commands received by the keypads can now be sent back to the source equipment via the
Opus 500 System. It is then possible to control the source equipment from the remote
rooms by using the source equipment's own remote controls or through a learning remote.
The Opus Learning Remote can fully control the keypads, ‘learn’ the source's remote
controls and change source input on the amplifier, etc.

Opus WCU330 Specifications

General

Brand	Opus
Model	WCU330
Category	Control Unit
Language	English