11
12
If a measurement is tagged with a label that has limits
set, the result will be presented as a PASS or a FAIL.
In the event of a PASS, the user can be confident in their
water quality. No action must be taken.
If the result is a FAIL, then the user must take some further
action. Kemio enables rapid decision making.
Once this action is taken, this and/or the root cause of the
problem can be documented in the Notes section of the
test and tagged to the FAIL result for future reference.
To manage labels and limits, see p. 15.
To enable tagging labels see p. 28.
Kemio corrects for dilution factors automatically. The
displayed result is calculated according to the dilution factor
which is programmed into the label, eliminating the need for
the user to do any calculation.
To manage labels and dilution factors, see p. 15.
To enable tagging labels see p. 28.
Process Control
Actionable Results
Dilution
To manage labels, see p.15.
To enable tagging labels see p.28.
To correlate with corrective action. By using labels with limits,
each test will either be a PASS or a FAIL. Every out-of-spec
result (FAIL) should have some corrective action. Failed
results can be monitored using the test history (p. 6) to
ensure that the process is being followed correctly.
See p.28 'Scanner Settings' to configure Kemio to require
users to scan the batch code every test.
See p.31 for details about batch codes.
Limits and Pass/Fail Results
To Next Page
Loading...
Need help?
General
