Speaker System Setting <CY-PA4003N>
(continued)
Speaker System Setting <CY-PA2003N>
1-channel Speaker System (Monaural)
2-channel Speaker System (Stereo)
Subwoofer
(Bridge connection)
(Monaural)
INPUT
RCA cord (option)
(from Head Unit output terminal)
Speaker output
Left
(min. 2 )
Right
(min. 2 )
INPUT
RCA cord (option)
(from Head Unit output terminal)
Speaker output
LeftRight
(min. 4 )
2CH Input
4-channel Speaker System
2-channel Speaker System
Input the left channel (white).
RCA cord (option)
(from Head Unit output terminal)
Input the right channel (red).
Speaker output CH A
Speaker output CH B
Input the left channel (white). Input the right channel (red).
Not used.
Speaker output CH A
Left (min. 4 )
Speaker output CH B
(Bridge connection)
Note:
The fader control is ineffective.
The speaker outputs A and B are at the same
level.
The 3-channel speaker output is not allowed
with the 2-channel input connection.
When the Head Unit is connected to the RCA
cord, note that the RCA white and red leads
differ in color from the unit terminals.
(Bridge connection)
Right (min. 4 )
Note:
This is not a monaural output.
The 3-channel speaker output is not allowed
with the 2-channel input connection.
When the Head Unit is connected to the RCA
cord, note that the RCA white and red leads
differ in color from the unit terminals.
Switch to 2CH.
Switch to 2CH.
Left
(min. 2 )
Right
(min. 2 )
Left (min. 2 )
Right (min. 2 )
Not used.
Special Application
Example: If the Head Unit only has a single pre-out,
connect it to this unit for 4-channel audio output.
RCA cord (option)
(from Head Unit output terminal)
Special Application
Example: If the Head Unit only has a single pre-out,
connect it to this unit for 2-channel audio output.
To Next Page
Loading...
Need help?
General