6. Timer Operation
14
(EN)
• When setting the timer, make sure the current time on the remote controller
is accurate.
• The timer’s clock can only be set when the display of the remote controller
is ON.
• After setting the timer, put the remote controller for in a place where its
signal will reach the receiver of the indoor unit. (When the time set for the
timer is reached, a signal is sent from the remote controller to start or stop
the unit.)
Using the Timer
1. Press either
/ of the
or
, and
while the time is being displayed, if you
press
/ again, a scheduled time can
be set.
The time last set on the timer is displayed.
“--:--” indicates time to change the batteries.
2. Press either / of the
or
and
set the timer to the desired time.
Every time you press / , the time changes in
10 minute increments. If you press and hold the
button, the time changes quickly.
3. After setting the timer, if you press , the
time you set changes to a steady display,
indicating settings are complete.
After the timer setting is displayed for three seconds,
the display reverts to the current time.
1, 23
To Next Page
Loading...
Need help?
General
