SQT0994
3
(For the AC mains plug of three pins)
For your safety, please read the following text
carefully.
This appliance is supplied with a moulded three
pin mains plug for your safety and convenience.
A 5-ampere fuse is fitted in this plug.
Should the fuse need to be replaced please
ensure that the replacement fuse has a rating of
5-ampere and that it is approved by ASTA or BSI
to BS1362.
Check for the ASTA mark Ï or the BSI mark Ì
on the body of the fuse.
If the plug contains a removable fuse cover you
must ensure that it is refitted when the fuse is
replaced.
If you lose the fuse cover the plug must not be
used until a replacement cover is obtained.
A replacement fuse cover can be purchased from
your local dealer.
Before use
Remove the connector cover.
How to replace the fuse
The location of the fuse differ according to the
type of AC mains plug (figures A and B). Confirm
the AC mains plug fitted and follow the
instructions below.
Illustrations may differ from actual AC mains plug.
1. Open the fuse cover with a screwdriver.
2. Replace the fuse and close or attach the fuse
cover.
Please check and identify the supplied
accessories.
(Product numbers are correct as of August 2015.
These may be subject to change.)
• Do not use AC mains lead with other equipment.
Insert batteries
Insert so the poles (i and j) match those in the
remote control.
Caution for AC Mains
Lead
Fuse cover
Figure A Figure B
Figure A Figure B
Fuse
(5 ampere)
Fuse
(5 ampere)
Supplied accessories
Remote control (N2QAYB001059): 1pc.
Batteries for remote control: 2 pcs.
AC mains lead (K2CT2YY00098): 1pc.
RF coaxial cable (K2KYYYY00247): 1pc.
HDMI cable (K1HY19YY0011): 1pc.
About descriptions in these operating
instructions
• Pages to be referred to are indicated as “> ±±”.
(Alkaline or manganese batteries)
DMR-EX97EB_eng.book 3 ページ ２０１５年８月２４日 月曜日 午後１時２８分
To Next Page
Loading...
Need help?
General
