79
RQT9058
No sound.
Low volume.
Distorted sound.
Cannot hear the desired
audio type.
Check the connections and the “Digital Audio Output” settings. Check the
input mode on the amplifier if you have connected one.
56, 65
Check audio/video (AV) cables.
8
Check if TV is muted.
−
Check if amplifier is muted.
−
Press [AUDIO] to select the audio.
29, 35
Sound is not output while fast-forwarding during chasing playback and
simultaneous record and playback.
−
Set “V. Surround Sound” in the Audio menu to “Off” in the following cases:
– When using discs that do not have surround sound effects, such as
Karaoke discs
– When playing multilingual broadcast recordings
51
The sound effects will not work when the bitstream signal is output from the
HDMI AV OUT terminal or the DIGITAL AUDIO OUT terminal.
−
Audio may not be heard when more than 4 devices are connected with
HDMI cables. Reduce the number of connected devices.
−
When the DIGITAL AUDIO OUT terminal is used for audio output and the
unit is connected to the television with an HDMI cable, set “HDMI Audio
Output” to “Off” in the Setup menu.
60
Depending on the connected equipment, the sound may be distorted if this
unit is connected with an HDMI cable.
−
Cannot switch audio.
If you want to switch between the main audio or SAP audio, then output
both audio signals from the external equipment connected to this unit and
record the program on a DVD-RAM or Video tape.
21
You have used a digital connection. Set “Dolby Digital” to “PCM” or connect
using an audio cable (analog connection).
56, 65
There are discs whose audio cannot be changed due to how the disc was
created.
−
Playback Issues Sound
Page
Reference
To Next Page
Loading...
Need help?
General
