Connecting to a PC or Printer
106
VQT0S19
Connecting to a PC
• By connecting the camera to a computer,
you can upload your pictures, then use
the software on the included CD-ROM
([LUMIX Simple Viewer] and
[PHOTOfunSTUDIO] for Windows
®
) to
print or send your images by e-mail.
• If you use Windows 98/98SE, install the
USB driver and then connect it to the
computer.
• For details about [LUMIX Simple Viewer]
and installation, refer to the separate
operating instructions for PC connection.
A : AC adaptor (DMW-AC5; optional)
• Make sure this unit is off before
connecting or disconnecting the AC
adaptor (DMW-AC5, optional).
B : USB connection cable (supplied)
C : This message appears during data
transfer.
DE: Check the facing of the connector and
push straight in.
1
Switch the camera on and set
[USB MODE] to [PC] in the setup
menu (P105).
• If you have set [USB MODE] to
[PictBridge (PTP)], the computer may
show an error message.
Click [Cancel] to close the dialog and
disconnect the cable from the computer.
Change the setting to [PC] and reconnect
the cable.
2
Connect the camera to a PC via
the USB connection cable B
(supplied).
• Connect the USB connection cable with
the [f] mark facing the [w] mark on
the [DIGITAL] socket.
• Hold
D and then insert or pull the USB
connection cable straight.
Do not try to force the connector in
backwards or sideways. This can damage
this unit and the equipment you are
connecting.
[Windows]
The drive appears on the [My Computer]
folder.
• If it is the first time you are connecting the
camera to a PC, the required driver is
installed automatically so that the camera
can be recognized by the Windows Plug
and Play, then it appears on the [My
Computer] folder.
[Macintosh]
The drive appears as [NO_NAME] or
[Untitled].
B
D
E
A
C
ACCESS
To Next Page
Loading...
Need help?
General
Weight and Dimensions
