10. Recording Videos
DVQX1961 (ENG)
112
– Change the [System Frequency]
– Set the [Variable Frame Rate]
– Switch the [Rec Quality] between 47.95p/23.98p and a different recording frame
rate
– Change the following [Time Code] setting items
[Count Up], [Time Code Value], [Time Code Mode], [TC Synchronization]
0 To restore the slave state, reconnect the BNC cable to the external device while set
as follows.
The time code signal (LTC signal) can be input just by connecting.
– [ ] mode
– [Count Up] ([Time Code]): [FREE RUN]
– [TC Synchronization] ([External TC Setting] in [Time Code]): [TC IN]
This section describes the use of AF when video recording.
[Continuous AF]
You can select how to set the focus in AF when recording videos.
¨ [ ] ¨ [ ] ¨ Select [Continuous AF]
0 Even when the system frequency differs between the camera and the external
device, their initial time code values may be synchronised. Bear in mind,
however, that the time codes lose sync as they count up.
Using AF (Video)
0 The functions described below work with both pictures and videos:
Please also refer to that section.
– Focus Mode: l 44
– AF Mode: l 64
– AF Area Movement Operation: l 68
– MF: l 69
– Zoom: l 71
DC-S1HGN-DVQX1961_eng.book 112 ページ ２０１９年８月８日 木曜日 午後５時５５分
To Next Page
Loading...
Need help?
General
