Page 26 Issue 2 22/4/98 MPC2000D
9.7. MPC2000D Data Display Pages
The following menus can be displayed by the Data Page Key:
Measured Data
Calculated Data
Logical Inputs/Contact Status
Statistical Data
Fault Data
Each data page provides the following displayed information:
Measured Data
Phase and Line Voltages (+/- 1.0%)
Phase Currents (+/- 1.5%) Total Real Power
Earth Fault Current (+/- 1.5%) Total VA Power
Channel Resistance (+/- 3.0%) Power Factor
Calculated Data
Motor Load as a % of FLC (+/- 1.0%)
Thermal Capacity as a % of FLC (+/- 1.5%)
Time to Trip in Minutes and Seconds (+/- 2.0%)
Time to Start in Minutes and Seconds (+/- 2.0%)
Unbalance Current as a percentage (+/- 2.0%)
Logical Inputs/Contact Status
Drive Status
Contactor A N/O
Contactor A N/C
Contactor B N/O
Contactor B N/C
Plant Interlock
Isolator
Start A Input
Start B Input
Stop Input
Local/Remote Control Status
PLC/Serial Port
PLC Control A
PLC Control B
PLC Reset
Speed Switch
Authorise Key
Emergency Stop
External Fault 2
External Fault 3
To Next Page
Loading...
Need help?
General