P&B MPC2000D User Manual

Page 30 Issue 2 22/4/98 MPC2000D
9.9. MPC2000D Data Pages Summary
MEASURED DATA
VP1, VP2, VP3 Volts
VL1, VL2, VL3 Volts
I1, I2, I3 Amps Total Real Power Watts
E/F Current Amps Total VA Power VA
R1, R2, R3 Ohms Power Factor %
CALCULATED DATA
Motor Load %
Thermal Capacity %
Time to Trip Min then Sec
Time to start Min then Sec
Unbalance Current %
LOGICAL INPUTS
Drive Status Available/Unavailable/Running
Contactor A N/O Open/Closed
Contactor A N/C " "
Contactor B N/O " "
Contactor B N/C " "
Plant Interlock Open=locked out/closed=run enable
Isolator " " " " " "
Start A Input Open/Closed
Start B Input " "
Stop Input " "
Local/Remote Input Closed=remote/open=local
PLC/Serial Port Input Open=PLC/closed=S.Port
PLC Control A Open=stop/closed=start/run
PLC Control B " " " " "
PLC Reset Open/closed
Speed Switch Open=high speed/closed=low speed
Authorise Key Open=locked/closed=unlocked
Emergency Stop Closed=run enable/open=stop
External Fault 2 " " " " "
External Fault 3 " " " " "
or
External Test Open=run enable/closed=test
STATISTICAL DATA
Total Run Time Hours
Total # of starts
Total # of Trips
Last ST. Period Secs
Last ST. Peak I Amps
FAULT DATA
LAST TRIP Description
LAST ALARM Description
FAULT I1,I2,I3 Amps
Fault Io Amps
Fault V1,V2,V£ Volts

P&B MPC2000D Specifications

General

Brand	P&B
Model	MPC2000D
Category	Controller
Language	English