www.panduit.com 2
The beacon controller can be mounted to a cabinet. It is DC-powered and requires an AC-to-CD
power brick. The beacon controller has a standard 10/100 Ethernet connection to the network side
and a screw-down terminal block on the beacon side. The beacons are connected to the relay
controller via 12AWG wire. Typically, the
beacon controller controls one beacon in the same cabinet as the beacon controller and another
beacon in an adjacent cabinet. To fully deploy the beacon function, every cabinet would need a
beacon, whereas, only every other cabinet would need a beacon controller.
Bill of Materials
The Bill of Material for the beacon, beacon controller, and associated items are shown in Appendix I.
The beacon controller is a third-party device and cannot be purchased through Panduit. Beacons can
be purchased directly from the manufacturer or through Panduit. Note: Panduit provides limited
support for third party devices.
Wiring Diagrams
The wiring diagram is shown in Appendix II. Power is connected to the first 2 screw terminals and to
each set of screw terminals controlling the beacons. Use 12AWG wire to connect the beacons to the
respective screw terminals as shown.
To Next Page
Loading...
Need help?
General
