Panduit SmartZone User Manual

www.panduit.com 4
TECHNICAL REFERENCE
Performing the Procedure
The beacon controller must first be setup using its web-based user interface. See the Xytronix
WebRelay X301 Quick Start guide available on the manufacturer’s website, www.controlbyweb.com,
for details.
The IP address and other network parameters should be set up for the customer's environment along
with SNMP community strings, SmartZone server IP address and beacon controller name.
IP Address
The IP address is setup on the Network tab.
SNMP Community String
In order for SmartZone to write to the Beacon Controller, the SNMP community string must be set up.
This is done on the Password tab of the web interface under the Control password section as shown
below. Set Enable Control password to Yes and type the password. The password should also be
entered into SmartZone’s SNMP strings in the SNMP tab in the System Administration module.

Panduit SmartZone Specifications

General

Brand	Panduit
Model	SmartZone
Category	Network Hardware
Language	English