1) Press "Menu" to enter the Menu Settings interface.
2) Press "OK" to select the "System Setting" option.
3)
Press direction key “▲” or “▼” to select options of “Auto off set”, press “OK” to set of
condition and off delay.
Note: Set auto off condition:
• Shutdown under no-port state (default configuration): no port is connected,
Wi-Fi function deactivated,printer is under standby or sleep mode.
• Shutdown under idle state: the printer is under standby or sleep mode.
• If auto off condition is satisfied, printer will be off at the preset time.
• After printer is off, power consumption is 0.5W or lower.
• Individual countries (or regions) do not support auto off setting.
12.1.7. Auto shut-off setting
“Auto shut-off setting” to set off condition and off delay of printer.
12.1.6.Print a Page for Clean & Fix
"Print a Page for Clean & Fix"function can clean the toner, paper powder and other
inpurities, so as to realize better printing effect.The printer will start up Print a Page for
Clean & Fix function automatically after the printer has printed a certain number of
pages. You can also launch Print a Page for Clean & Fix function manually by setting
up the printer panel. The steps are as follows:
1) Press "Menu" to enter the Menu Settings interface.
2) Press "OK" to select the "System Setting" option.
3) Press “▲”or“▼”and select "Clean & Fix" option, then press "OK" to start cleaning and
fixing of the fuser unit.
To Next Page
Loading...
Need help?
General