Safety Precautions
Laser Safety
The laser radiation is harmful to the human body. Since laser components are completely
The following label is
attached to the laser components inside the printer:
Safety Warning
Please note the following safety warnings before using the printer:
Warning
Plugging and unplugging the power cord plug with a wet
hand can result in an electric shock.
The fuser unit is hot when and after printing. Touching the
fuser unit (the shaded area as shown) may cause burns!
The fuser unit is attached with a high temperature warning
label. Please do not remove or damage this label.
sealed in the printer, laser radiation will not leak. To avoid laser radiation, please do not
randomly disassemble the printer!
The printer follows the provisions of Class 1 laser products under CFR standard. The
printer has a Class III b laser diode, which has no laser radiation leakage among laser
components.
The laser components shall complies with the requirements of: U.S. Code of Federal
Regulations, 21 CFR 1040, IEC 60825-1.
There is high-voltage electrode inside the printer.
Before cleaning the printer,make sure the power is turned off!
II
Disconnect the power supply
The product should be placed close to or easily accessible to power sockets, so as to
allow easy disconnection of power supply!
To Next Page
Loading...
Need help?
General