8.1.3.NFC function
NFC function allows non-contact point-to-point data transmission between electronic
devices. To use this function, you need to install the Pantum printer App on a mobile
phone that supports NFC, or conduct Mopria mobile printing after finishing Wi-Fi Direct
connection through NFC function.
Note： • NFC recognition may not be used normally affected by the material
of phone cover.
• Touch
time and distance may differ because of the mobile phones used.
8.1.3.1.Preliminary preparations
1.Printer with Wi-Fi Direct function.
2.Android 5.0 or higher version mobile devices support NFC function and Wi-Fi Direct function.
8.1.3.2.How to use NFC function to print
1.
Inspect if the NFC and Wi-Fi Direct function are enabled on the mobile device and if Wi-Fi
Direct function of printer is enabled.(Please refer to Chapter 9.2 for how to enable Wi-Fi Direct
function).
2.
Knock gently the NFC mark that indicates the NFC antenna
(on the back of the mobile device generally) on the printer and then wait for several seconds;
then, the printer application will start and the mobile device will connect to the printer.
1.Turn on printer power.
2.
Connect the Android mobile device
with wireless network of the printer
(Please refer
to
Chapter 5 for how to connect).
3.Open the files you need to print with Adobe Reader on the Android device.
4.
Click .
5.Tap "Print".
6. Please make sure the Pantum printer is selected.
If you selected other printer (or failed to select any printer), please tap the pull-down
menu of printer, and select your Pantum printer.
7.Set
printing
parameters,
e.g.
print
pages.
8.
Tap "Print".
Note： • If printing fails, please inspect if the Android device is connected to the
wireless network where the printer is connected to.
•
If the Android mobile device did not detect any printer, check whether
the
printer is powered
on and the printer is turned on.
To Next Page
Loading...
Need help?
General