EVOHD User Manual 11
To Force arm:
1. Enter your [ACCESS CODE].
2. Press the [
FORCE] button.
3. If you have access to more than one area, select the area(s) you wish to Force arm (refer to section 4.1).
5.6 Bypass Programming
You can bypass certain zones when you arm the protected area(s). When a zone is bypassed, it will be ignored
the next time your system is armed. Once your area is disarmed, the system will unbypass the zone.
To Bypass a zone:
1. Enter your [ACCESS CODE].
2. Press the [
BYP] button.
3. Enter the zone number (i.e. 01, 02,...96), or use the [] and [] buttons and press [
BYP] once the zone you
want to bypass appears on the screen. If bypassed, the byp light does not appear on the screen and the
keypad emits a rejection beep, you may not have access to bypass that zone.
4. Repeat step 3 until all zones you want to bypass have been selected.
5. Press the [
ENTER] button to save and exit.
To view all bypassed zones.
1. Enter your [ACCESS CODE].
2. Press the [
BYP] button.
3. Scroll through the zones using the [] and [] buttons to view zone status. (LCD Keypads)
NOTE: In order to bypass a zone, the following conditions must be met:
• The zone must have the Bypass option programmed by your installer.
• The Bypass option must be enabled in your User Options.
• Your user access code must have access to the zone’s Area Assignment.
• The zone’s area must be disarmed before the zone can be bypassed.
WARNING: Fire Zones cannot be bypassed.
5.6.1 Bypass Recall
Bypass Recall reinstates the zones that were bypassed the last time your system was armed.
To activate Bypass Recall:
1. Enter your [ACCESS CODE].
2. Press the [
BYP] button.
3. Press the
[MEM] button.
Zones bypassed the last time your system was armed are bypassed.
4. Press the [
ENTER] button to save and exit.
To Next Page
Loading...
Need help?
General
