Using Access Control 8
22 EVOHD User Manual
Using Access Control 8
8.1 Entering & Exiting
Depending on how your system is installed and on the type of keypad, there are various ways to enter and exit
Access Control doors:
• Present your Access Control card to the reader or the EVO641R or DGP2-641RB
keypad. The system will verify that the card is allowed access according to its
assigned Access Level and Schedule. If it is accepted, the system will unlock the
door. The reader’s light can be programmed by the installer to turn green or
extinguish briefly to indicate that the door can be opened.
• When the motion detector detects movement (Request for Exit), it will unlock the
door to permit passage from inside.
• Enter your user access code on the keypad and press
[ACC].
• If the Access Control door is on a “Door Unlocked Schedule”, you may be able to
open Access Control doors without using a user access code or an Access Control
card. Depending on the door’s programming, the door can remain unlocked
during the entire programmed schedule or the door can unlock once a valid
Access Control card is presented to the reader during the schedule and then will
remain unlocked for the remainder of the schedule.
8.2 Arming and Disarming with Card
8.2.1 Arming with Card
• presented to a door during its assigned Schedule (refer to step 8 in section 7.5.1).
• presented to a door within its assigned Access Level (refer to step 8 in section 7.5.1).
• programmed to allow arming (options
[4] and [5] in (see section 7.7).
• assigned to all areas that are assigned to the Access Control door (refer to step 7 in section 7.5.1), or assigned
to at least one of the areas assigned to the Access Control door depending on how your installer has
programmed the Access Control door.
8.2.2 Disarming with Card
To disarm and unlock an Access Control door when the area assigned to it is armed, present your Access Control
card to the reader or EVO641R / DGP2-641RB keypad (door). The Access Control card must be:
• presented to a door during its assigned Schedule (refer to step 8 in section 7.5.1).
• presented to a door within its assigned Access Level (refer to step 8 in section 7.5.1).
• programmed to allow disarming (option [2] in (see section 7.7).
• assigned to all areas that are assigned to the Access Control door (refer to step 7 in section 7.5.1), or assigned
to at least one of the areas assigned to the Access Control door depending on how your installer has
programmed the Access Control door.
8.3 How Access Control Works
To illustrate how Access Control functions, we will use three simple Access Control System examples:
To Next Page
Loading...
Need help?
General
