10
Parker Hannifin Corporation
Proportional DC Valves
Series D*FC, D*1FC
Operation Manual
D_FC 5715-686 UK 07.02.2019
Scope of supply
Please check immediately after receiving the valve,
if the content is matching with the specified scope
of supply. The delivery includes:
• valve
• operation manual
The central connector assembly has to be ordered
separately and is not included in the delivery.
Please check the delivery immediately after
receiving the shipment for apparent dam-
ages due to shipping. Report shipment
losses at once to the carrier, the insurance
company and the supplier!
Intended usage
This operation manual is valid for proportional direc-
tional control valves D*FC/D*1FC series. Any dif-
ferent or beyond it usage is deemed to be as not
intended. The manufacturer is not liable for warranty
claims resulting from this.
Information on the process of technical changes
We reserve the right to make technical changes
as a result of further development of the product
described in these operating instructions. Figures
and drawings in these instructions are simplified
depictions. As a result of developments, improve-
ments and changes to the product, it is possible that
the figures are not fully consistent with the valve in
operation. The technical details and dimensions are
non-binding. They may not form the basis of any
claims. Copyright reserved.
Information on warranty and liability
The manufacturer does not assume liability for
damage due to the following failures:
• incorrect mounting / installation
• improper handling
• lack of maintenance
• operation outside the specification
Do not disassemble the valve! In case of
suspicion for a defect please return it to
Parker.
CE mark
The CE mark appears on the main nameplate. If the
product is installed as part of a larger machine, this
larger machine is in turn subject to EU directives
and must therefore obtain a general CE mark for the
machine as a whole. The machine must not enter
circulation in the EU until this is done. The legal
requirements corresponding to the CE mark can be
found in section "Other applicable standards / rules".
Personnel requirements
The product may only be used, installed, removed,
operated and maintained by specialist personnel.
For the purposes of these instructions, a specialist
is defined as someone who, on the basis of their
education, expertise and professional experience,
is able to correctly evaluate and carry out the tasks
and duties assigned to him/her, and identify and
correct potential hazards. Skilled, semi-skilled or
trained personnel may not use this product under
their own responsibility unless they have the required
specialist knowledge. Otherwise, they may only
use the product under the constant supervision of
a specialist person.
Compliance with other rules and instructions
Carry out transport and installation/repair activities
only in accordance with the valid and applicable
safety and accident prevention regulations issued
by the trade associations.
The valve contains hydraulic oil. The normal lo-
cal environmental protection requirements must
therefore be met when handling the product. The
particular circumstances of each place of installation
mean that instructions must be followed in order to
install and use the product safely.
2. Safety
Safety instructions
Please read the operation manual before instal-
lation, startup, service, repair or stocking! Paying
no attention may result in damaging the valve or
incorporated system parts.
To Next Page
Loading...
Need help?
General
