Parkside Performance PASSP 20-Li A2 User Manual

PASSP 20-Li A2
GB
│
IE
│
7 ■
Safety guidelines for battery
chargers
■ This tool may be used by children
aged 8 years and above and by
persons with limited physical,
sensory or mental capabilities or
lack of experience and knowledge,
provided that they are under super-
vision or have been told how to use
the tool safely and are aware of the
potential risks. Do not allow children
to use the tool as a toy. Cleaning
and user maintenance tasks may
not be carried out by children
unless they are supervised.
■ To avoid potential risks, if the appli-
ance power cable is damaged, it
must be replaced by the manufac-
turer, its customer service or by a
qualified technician.
The charger is suitable
for indoor use only.
WARNING!
■ To avoid potential risks, if the appliance
power cable is damaged, it must be replaced
by the manufacturer, its customer service or
by a qualified technician.
ATTENTION!
♦ This charger can only charge the following
batteries: PAP 20 A1/PAP 20 A2/
PAP20A3/PAP20 B1/PAP20 B3.
♦ A current list of battery compatibility can be
found at www.Lidl.de/Akku.
Before use
Charging the battery pack
(seefig.A)
CAUTION!
► Always unplug the appliance before you
remove the battery pack from or connect the
battery pack to the charger.
NOTE
► Never charge the battery pack at an ambient
temperature of below 10°C or above 40°C.
If a lithium-ion battery is going to be stored
for an extended period, the charge level
should be checked regularly. The optimum
charge level is between 50% and 80%. The
storage climate should be cool and dry and
the ambient temperature should be between
0°C and 50°C.
♦ Connect the battery pack
to the high-speed
battery charger (see fig. A).
♦ Insert the mains plug into the mains power
socket. The green charge control LED
lights
up briefly, then the red charge control LED
lights up.
♦ The green control LED
indicates that the
charging process is complete and the battery
pack is ready for use.
ATTENTION!
♦ If the red control LED
flashes, this means
that the battery pack has overheated and
cannot be charged.
♦ If the red and green control LEDs both
flash, this means that the battery pack is
defective.
♦ Push the battery pack
into the appliance.
♦ Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.

Parkside Performance PASSP 20-Li A2 Specifications

General

Brand	Parkside Performance
Model	PASSP 20-Li A2
Category	Power Tool
Language	English