Parkside 328024 2001 User Manual

29
IEGB
Insert a suitable 6-point bit in the bit holder
(
3). Because of the 6-point bit holder, it
may be that you need to rotate the bit slight-
ly. Slide the bit right into the bit holder
(
3). The bit is held fi rmly by the duct and
the magnetic holder.
Use extension bit holder
Remove the current bit (
2) from the bit
holder (
3).
Insert the extension bit holder (
12) into the
bit holder (
3). It may be that you need to
rotate the extension bit holder (
12) slightly
because of the 6-point bit holder. Com-
pletely insert the extension bit holder (
12)
into the bit holder (
3). The extension bit
holder (
12) is held fi rmly by the duct and
the magnetic holder.
To remove the extension bit holder (
12),
simply remove the extension bit holder from
the bit holder (
3).
Cleaning and
maintenance
Contact our Service Centre about
repairs and servicing not described
in this manual. Only use OEM
parts. Risk of injury!
The following cleaning and servicing
should be done regularly. This will ensure
a long and reliable service life.
Cleaning
Do not spray the appliance
with water and do not im-
merse it in water. Electric
shock hazard!
• Keep clean the ventilation slots, motor
housing and handles of the appliance.
Use a damp cloth or a brush.
Do not use cleaning agents or solvents.
You may otherwise irreparably dam-
age the appliance.
Maintenance
The appliance is maintenance free.
Storage
• The device may not be stored in a
damp environment or in places with
corrosive gases; it must be stored in
a dry location outside of the reach of
children.
• Keep the surface of the device clean
and only use a dry cloth for cleaning.
• The device must not be dismantled. If
the device is damaged, contact the sup-
plier or manufacturer.
• Store the battery only in a partially
charged state. The state of charge
should be 40 – 60 % over a longer
storage period.
• During a longer storage period, check
the state of charge of the battery and
recharge if necessary roughly every
3months.
• Store the equipment between 0° C and
45° C. During storage, avoid extreme
cold or heat so the battery does not
lose power. In order to keep the battery
well charged, avoid exposing the ap-
pliance to extreme heat or cold in stor-
age

Parkside 328024 2001 Specifications

General

Brand	Parkside
Model	328024 2001
Category	Power Screwdriver
Language	English