Parkside PKGA 16 A1 User Manual

GB MT
4 0
Sawing
Wear eye protection.
• Use only undamaged sawblades in
perfect condition. Only use metal saw-
blades for metalworking.
• Ensure your stance is stable and hold
the appliance tightly with both hands
and away from your body.
• Before sawing the workpiece, check
for hidden foreign objects such as
nails, screws. These must be removed.
• Plunge cuts may only be made in soft
material such as wood or plaster-
board.
Selection of sawblade
Wood sawblade
for wood, plastic, plaster-
board
Metal sawblade
or meta heet roe
and tubes
Plunge sawblade
for soft materials like
wood or plasterboard
Sanding
• Use a dust extraction system when sand-
ing with the multi-sander attachment.
• Move the appliance against the work-
piece once it is switched on.
• Clean the sanding plate before you at-
tach a sanding sheet.
• Only work with sanding sheets in per-
fect condition to achieve good sanding
results.
• Work using low and even pressure.
This protects the appliance and the
sanding sheet.
• Do not use the same sanding sheet to
sand different materials (e.g. metal
and then wood).
Selection of sanding sheet
Grain size P Application
60
for pre-sanding rough wood
surfaces
80 / 120 for plain sanding
240
or ne ann o rme
and painted surfaces
Scraping
• Use a high oscillation rate when scrap-
ing.
• Work using low pressure and at a low
angle in order not to damage the sub-
strate material.
Cleaning/Maintenance
Repair and servicing work not
described in this manual should
always be carried by our Service
Centre. Use only original parts.
Switch off the device and remove
the battery from the device before
working with or transporting it.
The following cleaning and servicing
should be done regularly. This will ensure a
long and reliable service life.

Parkside PKGA 16 A1 Specifications

General

Brand	Parkside
Model	PKGA 16 A1
Category	Power Tool
Language	English